Danfoss Compressor
Model: GPY12RDA 123B1580
Horsepower: 3/8HP
Voltage: 115V
Phase: 1Ph
Frequency: 60Hz
Refrigerant: R134A
Segment usage: Refrigeration MT
HMBP
Danfoss Compressor
Model: NF9FX
Horsepower: 1/5HP
Voltage: 115V
Phase: 1Ph
Frequency: 60Hz
Refrigerant: R134A
LBP/MBP
Danfoss Service Thermostat 077B7002
Danfoss Service thermostat; with accessories,
Product Type: B4
Type designation: Service thermostat; with accessories,
Used for product: Refrigerators; with manual defrost,
Warm cut-in [°C]: 0.0,
Warm cut-out [°C]: -7.5,
Cold cut-out [°C]: -22.0,
Cold cut-out [°C]: -22.0,
Capillary tube length [mm]: 1300
Full Gauge
The MT-512EL-2HP 12/24V features a single relay output, for cooling or heating purposes, combined to a cyclical timer for natural defrost. The natural defrost can be forced or performed through an off refrigeration cycle. It also features a configurable digital filter, which has the aim of simulating an increase of mass in the environment sensor, thus increasing its response time, that is, the sensor response becomes slower. In addition to those features, the MT-512EL-2HP 12/24V has tamper-proof function that blocks the keypad preventing unauthorized users changing its settings, and a control function shutdown that deactivates the controlling outputs turning the instrument into a digital temperature indicator.
Full Gauge
NTC sensor with thermoplastic polyester cable and individual isolation.
Digital Controller Accessories
The revolutionary Ranco® EasyProg enables storage of nine individual programs for Ranco Digital Controllers. It can copy the information from a standard controller and then download it to other controllers without the need for connecting it to a PC. Also, it can be connected to the PC through a USB port and the user can change the parameters using the Sitrad® Preset Editor. An RS-485 port and a Serial TTL port are used for communication with the Digital Controller.
* See the controller's manual to check if it is compatible with EasyProg before connecting them.
Full Gauge
The TCP-485-WIFI converter enables communication between Full Gauge Controls controllers and Sitrad through a WiFi data network using the standard TCP/IP communication. TCP-485 WiFi does not require Ethernet cabling to manage the installation.
Full Gauge
The TCP-485 serial device is used to transform the RS-485 standard to Ethernet signal (internet or intranet) thus allowing the controllers to communicate with Sitrad Pro software through wiring connection (RJ-45). It also allows connecting instruments remotely. Through the IP address of the TCP-485 Ethernet module, it is possible to access it wherever it is inside the company's network or on the internet.
Full Gauge
The CONV32 is used to connect to Sitrad Pro of up to 32 instruments with serial connection. It performs the communication between the controllers and the computer, by means of converting RS-485 signals from the controllers. The CONV32 is connected to the computer or Sitrad InBox by an USB cable.